Start-Up Instructions; Illustrated Description; Adjustment Operation - stayer LS 1200 B Manual De Instrucciones

gb
The grinding elements will be used exclusively for
their designated uses.
Part-off or roughing discs will not be used in this
electrical tool.
OTHER SAFETY INDICATIONS
Always hold the electrical tool with both hands on the
corresponding surfaces (motor casing and handle).
Hold smaller pieces to be processed in order to avoid
their involuntary displacement.
The power supply network voltage and the voltage
indications on the characteristics plate must coincide.
SYMBOLS USED
DANGER: This indicates an imminent danger. In the
case of non-compliance you will be at risk of death
or very serious injuries.
CAUTION: This indicates a situation that is possibly
dangerous. Non-compliance implies the risk of
injuries or material damages.
WARNING: This indicates advice regarding use
and important information.
SYMBOLS ON THE APPARATUS
Read the instructions before starting up the
equipment!
Use adequate protection!
Elimination of unused machines.

2 START-UP INSTRUCTIONS

ILLUSTRATED DESCRIPTION

1 ON/OFF switch
2 Interlocking button
3 Protective Housing adjustment screw
4 Protective Housing
5 Grip
6 Adjustment wheel to select the rotation speed
7 Earth connection cable
8 Gear head
9 Drum shaft
10 Satin drum
11 Washer
12 Drum retention screw
13 Distancing ring*
14 Drive roller*
15 Rubber roller *
16 Ventilation grilles
17 Spindle blocking button
18 Brush cover
* The accessories described and illustrated do not correspond to the
serial material included. The complete range of optional accessories is
detailed in our accessory programme.
3.OPERATING INSTRUCTIONS
IF YOU FIND THE MACHINE IN POOR CONDI-
TION, OR WITH PROTECTIONS OR MISSING
PARTS, DO NOT CONNECT IT AND CONTACT
THE TECHNICAL SERVICE.
START-UP
Disconnect the power supply plug before
performing any work in the electrical equipment.
Prior to start-up.
Unpack the electrical tool and check the volume handed
over is complete and determine if any damage occurred
during its transport.
On/Off (Fig. 2)
- Press switch 1, keeping it pressed down.
- To stop the tool release switch 1.
Continued operation/interlocking (Fig. 2)
- Press interlocking switch 2 on the machine.
- To turn it off, press interlocking switch 2 for its deactivation.
Rotation speed pre-selection (Fig. 3)
- To adjust the working speed, turn speed selection wheel
6 to the required value.
Hold the tool or the tool support (Fig. 4)
- Disconnect the plug from the power supply.
- Press the spindle blocking button 17 and keep it pressed
down.
- Loosen the screws with knurls 12 and remove both discs.
- Move the tool or the corresponding support over the tool
holder (position adjustment, key).
TOOL CHANGE
Gear.
Do not loosen the screws at the gear head (8)
during the guarantee period. Non-compliance
will lead to expiry of the manufacturer's
guarantee.

ADJUSTMENT OPERATION

Protection cover adjustment
The burnishing machine will always be used
with the protection cover in place (Fig. 5)
- 1. Loosen cover adjustment screw 3 (Fig. 5)
- 2.Adjust the protection cover in a position that is
appropriate for the task to be performed and in the
corresponding work position (Fig. 5)
- Adjust screw 3 once more.
GENERAL USE INSTRUCTIONS
Once turned off, the grinding tool continues
working briefly due to inertia.
Processing of flat surfaces (Fig. 6)
- Hold the electrical tool with both hands.
- For a decorative finishing of the surface:
- 18 -