Installing The Saw Blades - Bosch 0 607 595 100 Manual De Instrucciones

All manuals and user guides at all-guides.com
FoamC_bu_2609929157_t.fm Seite 6 Dienstag, 10. August 2004 12:36 12

Installing the Saw Blades

9
8
Unscrew the two knurled nuts 8 nd remove them to-
gether with the lock washers and the faceplate 9.
Choose the saw blade set 7 that matches the saw
blade guide 5 (see Accessories). Two serrated saw
blades move side by side in opposite directions within
the saw blade guide.
Put the saw blade set 7 together. Take care that the
unground sides of the saw blades are placed against
each other (and the printing on the saw blades is read-
able.
5
12
7
Insert the saw blade set 7 with the lengthwise slots into
the guide pin 12 of the saw blade guide 5.
Push the saw blades into the saw blade guide 5 and
slide them in individually as far as the respective stop
14 of the drive block.
2 609 929 157 • (04.08) T
The cross-slots of the saw blades should fit into the
catch pins of the drive blocks 13. The saw blades 7
should lie, as shown in the picture above, between the
drive blocks.
Tightly screw back on the face plate 9 with the knurled
nuts 8 and the lock washers.
Check that the saw blades are seated firmly in
the tool before you connect the tool to the air
supply. Saw blades that are not clamped properly in
the appropriate holder may slip out and can cause
damage to the workpiece or injury to you or others.
Installing the Footplate
12
Press the footplate 6 onto the saw blade guide 5.
Firmly tighten the clamping screw 15.
5
7
14
English–6
5
15
6
13