Beacon Lighting LUCCI AIRFUSION PEREGRINE Manual De Instrucciones página 10

Airfusion Peregrine Installation Instructions
•
Turn ON the fan and change the speed of the ceiling fan via the remote to check the operation and
successful paring.
•
If pairing has been unsuccessful, repeat these set of steps again.
Note: The fan supports control by up to 2 transmitter. To reset the fan to only can be controlled by one
transmitter, do the pairing process twice, but press and hold the "
seconds.
PAIRING REMOTE & RECEIVER – WHEN 2 OR MORE DC CEILING FANS ARE INSTALLED IN ONE
LOCATION
When two or more fans are located near each other, you may want to have the remote/receiver for each fan
set to a different code, so that the operation of one fan does not affect the operation of the other fan/s.
NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for each fan.
NOTE: Ensure power to the receiver is ON prior to pairing the remote with the receiver.
Remote / Receiver pairing for Ceiling fan 1:
•
Turn OFF the mains supply to the receivers of both ceiling fans 1 and 2.
•
Install the 3V DC battery in the compartment. Please make sure the polarity of the battery is correct.
(Fig.15)
•
Turn on the power to receiver 1. Keep the power OFF to receiver 2. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the remote will be ON).
•
Press and hold the "
to the receiver of ceiling fan 1.
If the fan has light kit attached, the light will flash on and off to indicate the paring process is activated.
•
Turn ON and change the speed of the ceiling fan 1 by the remote to check the operation and successful
paring.
•
If pairing has been unsuccessful, repeat these set of steps again.
Remote / Receiver paring for Ceiling fan 2:
•
Turn off the mains supply to the receivers of both ceiling fans 1 and 2.
•
Install the 3V DC battery in the compartment. Please make sure the polarity of the battery is correct.
(Fig.15)
•
Turn on the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the remote will be ON).
•
Press and hold the "
to the receiver of ceiling fan 2.
If the fan has light kit attached, the light will flash on and off to indicate the paring process is activated.
• Turn ON and change the speed of ceiling fan 2 by the remote to check the operation and successful
pairing.
• If pairing has been unsuccessful, repeat these set of steps again
9 | P a g e
" button of remote 1 for 3-5 seconds within 30 seconds of switching the power ON
" button of remote 2 for 3-5 seconds within 30 seconds of switching the power ON
" button of transmitter more than 10