Finishing The Installation; Using Your Ceiling Fan - Beacon Lighting LUCCI AIRFUSION PEREGRINE Manual De Instrucciones

Airfusion Peregrine Installation Instructions
INSTALLATION OF THE CANOPY (Fig. 14)
•
Loosen the 2 screws at the bottom of the mouthing bracket.
•
Slide the canopy up to the mounting bracket and align the key holes on the canopy with the screws on the
mounting bracket. Turn the canopy until it locks into place with the narrow section of the key holes and
secure it by tightening the two screws. Avoid damaging the electrical wiring prepared previously.
•
Slide the canopy cover ring up to the canopy and click in to cover the canopy cover screws.
NOTE: The remote and receiver will need to be paired after the installation of the ceiling fan.
NOTE: When two or more ceiling fans are installed in one location, please refer to the
instruction on the next page.
BATTERY INSTALLATION （Fig. 15）
BEFORE USING THE REMOTE TRANSMITTER
1 pc 3V CR2032 battery is required to operate the remote control.
1. Battery CR2032 is pre-installed in the remote. For first time use of the remote, remove the battery film before use.
(Fig. 15 a)
7 | P a g e

FINISHING THE INSTALLATION

Fig. 14

USING YOUR CEILING FAN

Battery film
Battery film
Fig. 10
Fig. 15a