CT4110, CTS4110
6.3
Using the toilet
The toilet lid remains in a position of approximately 70° (fig. 7 1, page 6).
I
NOTE
The slider must be closed while driving, and no liquid should be above
the slider.
➤ Before use, press the flush button
(fig. 7 2, page 6).
➤ Pull the slider (fig. 7 3, page 6) forward. Leave the slider open during use.
➤ After use, press the flush button
➤ Close the slider (fig. 8 2, page 6).
The cassette tank has a capacity of 19 l. When the indicator
can only be used a few more times.
I
NOTE
With a 3/4-filled cassette, use is only possible when the slider is open.
With a tilted position (such as lasting inclination of the vehicle), the
cassette may only be 3/4 full. Overflowing through the vent is possible.
6.4
Draining the cassette tank
Empty the cassette tank when the indicator
➤ Remove the cassette tank (chapter "Removing the cassette tank" on page 22).
➤ Press the release button in the middle of the handle and pull the handle out to its
end position (fig. 9, page 7).
A
NOTICE!
•
Do not shake the cassette tank vigorously.
•
Do not hang the cassette tank on a bicycle or other vehicle for trans-
portation.
•
Do not place heavy objects on the cassette tank during transport.
This can damage the housing and rollers.
➤ Bring the tank to the nearest designated disposal location.
➤ Press the release button in the middle of the handle and push the handle back
into the cassette.
EN
to allow some water to run into the bowl
again to rinse the bowl (fig. 8 1, page 6).
lights up.
Using the toilet
lights up, the toilet
23