Fastening Possibilities (B) - Rothenberger RODIACUT 150 Instrucciones De Uso

3.3 Fastening possibilities
a) Dowel fastening on concrete or brickwork (picture B-1)
 Measure and drill a mounting hole for the dowel fastening.
Concrete (Item no. FF35120)
Brickwork (Item no. FF35121)
 Carefully clean the drill dust from the borehole.
 Apply the concrete dowel with expansion wedge or brickwork dowel (can be re-used up to 5
times).
Concrete set: Turn the diamond knurl threaded bar into the dowel.
Brickwork set: Screw the diamond knurl threaded bar with the grommet and mounted nut in-
to the armature. Tighten the nut using an open-ended spanner.
 Attach the base plate (8) and fasten with the grommet and the wing nut.
b) Bracing with the quick clamp column (Item no. FF35015 picture B-2)
 Align the drill rig and attach the quick clamp column to the base plate of the drill rig.
 Extend the quick clamp column and clamp the drill rig.
Minimum room height:
Maximum room height:
Information: In order to avoid damage to the ceilings or walls by the quick clamp col-
umn, place a piece of wood or similar between the end of the column and the ceiling to
distribute the contact pressure over a larger area.
Please read and be sure to understand the supplied quick clamp column instruction
manual!
c) Vacuum set fastening (Item no. FF35710 = RC 150; FF35740 = RC 250; picture B-3) with
vacuum pump (Item no. FF35200)
 Place the cellular rubber ring in the groove incorporated in the base plate (8) of the drill rig.
 Connect the vacuum set to the vacuum pump by means of the quick coupling.
 Connect the vacuum pump to the mains supply and switch on.
 Position the base plate (8) and insert the vacuum connecting piece with 3-way ball valve in
the elongated hole of the base plate.
 Press firmly on the hand toggle of the ball valve and activate while simultaneously pressing
the base plate onto the ground.
Operate the ventilation button (9) in the foot plate to re-position the drill rig on the ground.
Max. drill range with vacuum technique:
The vacuum technique is only to be used on smooth ground, as an adequate vacuum
can only be produced here. Never suck in on plaster! The drill rig could break away
from the wall.
In the event of a power failure, the safety tank on the RODIA-VAC vacuum pump ensures that
the equipment remains firmly attached to the ground for approx. 1 - 2 minutes. This time period,
however, is strongly dependent on the impermeability of the system and the condition of the
ground.
Check the negative pressure constantly during drilling work. The pressure must not fall below
0,8 bar!
Remove the equipment from the wall immediately in the event of a power
failure. Danger due to the equipment falling off. Vacuum neutralised. Only work using
slight feed pressure!
Please read and be sure to understand the supplied vacuum pump instruction manual!
14
Diameter in mm
15 mm
20 mm
ca. 1,7 m
ca. 3,0 m
horizontal
vertical
ENGLISH
Depth in mm
65 mm
85 mm
Ø 150 mm
Ø 250 mm
(B)