Exiting Emergency Operation - Motorola Solutions APX NEXT Guia Del Usuario

If...
Emergency Call with Hot Mic
3 To exit Emergency Call, see
12.5
Sending Emergency Alarms with Emergency Calls
Procedure:
1 Press the preprogrammed Emergency button.
Your radio shows the following indications:
• The radio displays the confirmation message of a successful or unsuccessful
acknowledgment from the dispatcher.
• The radio exits Emergency Alarm and enters the Emergency Call state.
2 Perform one of the following actions based on the type of emergency call:
If...
Emergency Call
Emergency Call with Hot Mic
3 To exit Emergency Call, see
12.6

Exiting Emergency Operation

If an Emergency operation is triggered on your radio, the dispatch console or radios configured as
Supervisor can exit the Emergency operation.
Procedure:
Perform one of the following actions:
Then...
Speak into the microphone.
Exiting Emergency Operation on page
Then...
a Press and hold the PTT button.
b Speak into the microphone.
c To end the transmission and wait for a
response from the dispatcher, release
the PTT button.
Speak into the microphone.
Exiting Emergency Operation on page
MN005642A01-AP
Chapter 12 : Emergency Operation
NOTE:
The Hot Mic applies to the first
voice transmission from your ra-
dio during the Emergency call. For
subsequent transmissions in the
same Emergency call, you must
press the PTT button.
57.
NOTE:
The Hot Mic applies to the first
voice transmission from your ra-
dio during the Emergency call. For
subsequent transmissions in the
same Emergency call, you must
press the PTT button.
57.
57