Installing The Power Cord; Connecting The Compressor To The Concentrator - Invacare HomeFill II Manual De Instrucciones

3.5 Installing the Power Cord

1. Ensure the compressor A is on a hard flat stable surface, such as
a table or Ready Rack.
2. Make sure the power switch is in the Off (O) position.
3. Plug the power cord (Invacare supplied) into the electrical
connector B in the back of the compressor.
4. Plug the opposite end of the Invacare supplied power cord D
into the wall outlet C.
5. Leave a minimum of 3" (7.6 cm) clearance to the power cord
ends for disconnection access.
The power inlet acts as the mains disconnection device
to remove all power to the unit when the line cord is
disconnected.
1145804-E
All manuals and user guides at all-guides.com
3.6 Connecting the Compressor to the
Concentrator
1.
2.
3.
Insert one end B of the interconnect hose A (Invacare Supplied)
into the outlet fitting B on the back of the concentrator C.
Insert the opposite end of the interconnect hose into the inlet
fitting D on the side of the compressor E.
The metal tabs G on the concentrator outlet fitting
and the compressor inlet fitting F will pop out with an
audible "click" when the end of the interconnect hose
is properly installed.
Loop any excess interconnect hose and secure to the back of
the concentrator with the fastening straps.
Set-Up
15