Operating Instructions; Operation Decals On Sh Models; Connecting The Propass To The Tow Vehicle - TYCROP ProPass 180 Top Dresser Manual Del Operador

Operating Instructions

The ProPass 180 Top Dresser has balance, weight, and
handling characteristics that may be different from other
types of pulled equipment. Read this Operator's Manual
carefully.
With an option mounted, be aware of the ground
clearance when traveling on hills. For a ProPass mounted
on a tow-behind chassis, the ground clearance is 33 cm
(13 in) unloaded. For a ProPass mounted on a TYCROP
direct connect chassis, the ground clearance is 43 cm
(17 in) unloaded.
: Before loading the ProPass on or off of
I
MPORTANT
a trailer, remove the option to avoid damaging it.

Operation Decals On SH Models

Operation decals on your ProPass SH indicate operating
controls. Replace any decal that is damaged or lost.
0
2004 TY-CROP MANUFACTURING LTD.
TY-403: Option control
0
2004 TY-CROP MANUFACTURING LTD.
TY-404: Floor/conveyor control
2004 TY-CROP MANUFACTURING LTD.
TY-417: Floor on/off toggle; option on/off toggle
Operating Instructions
All manuals and user guides at all-guides.com
TYCROP Manufacturing Ltd.
10
TY-403
10
TY-404
TY-417
ProPass 180 Top Dresser Operator's Manual
Connecting the ProPass to the Tow
Vehicle
: Do not stand between the
W
ARNING
ProPass and the tow vehicle during
coupling.
1. Adjust the hitch height by turning the jack stand
handle(s) to keep the ProPass level.
: The hitch pin must be high-strength and
I
MPORTANT
approved for tow vehicles.
2. Connect the clevis-style hitch of the ProPass to the
tow vehicle using a 18 mm (3/4 in) diameter hitch
pin and safety clip (supplied with Jac 5
chassis). Install the hitch pin through the ProPass
hitch and the tow vehicle's draw bar on tow-behind
chassis and through the supplied hitch mount on
TYCROP direct connect.
3. Lower the hitch using the jack stand(s).
4. When the full weight of the ProPass has been
transferred to the tow vehicle's draw bar from the
jack stand(s), pull the pin holding the jack stand(s) in
place.
5. On tow-behind chassis turn the jack stand 90 degrees
counter-clockwise until the bottom of the jack stand
points to the rear of the ProPass. This is the traveling
position.
6. On TYCROP direct connect chassis move the jack
stands to the rear of the machine and turn them
90 degrees until the bottom of both jack stands points
to the center of the ProPass. This is the traveling
position.
: Raise and stow the jack(s)
C
AUTION
into the traveling position before towing
the ProPass.
7. Attach the pressure hose and the return hose to the
correct hydraulic outputs on the tow vehicle. The
return hose has an inline check valve. If the hoses are
reversed, some ProPass functions may run
th
wheel
Page 19