Figure 25: Mounting Brackets At Propass Rear; Figure 26: Electrical Connection On Work Vehicle For Sh Model; Figure 27: Electrical Connection On Work Vehicle For Eh Model - TYCROP ProPass 180 Top Dresser Manual Del Operador

Figure 24: Mounting brackets at ProPass rear
4. Turn off the engine and set the parking brake.
5. Lower each of the two rear storage jack stands until
the holes in the mounting bracket align with the
holes in the work vehicle's frame rail.
6. Insert the mounting pin and the safety pin, first at
one rear corner, then the other. If necessary, move
the storage stand legs to correctly align with the rear
mounting bracket holes.
7. Lower the rear storage jack stands. Remove and store
them.
: Do not operate the ProPass
C
AUTION
with the storage stand installed.
8. With one hand, lift and position the lift cylinder.
With the other hand, insert the existing locking pin.
(If necessary, start the work vehicle, then gently raise
or lower the lift cylinder until the hole in the
connecting arm of the cylinder aligns with the hole in
the ProPass mounting bracket.)
: Keep your hands and feet
C
AUTION
away from the engine when it is
running.
9. With the work vehicle in neutral gear and the parking
brake set, start the engine.
Operating Instructions
All manuals and user guides at all-guides.com
TYCROP Manufacturing Ltd. ProPass 180 Top Dresser Operator's Manual
10. Using the work vehicle's lift cylinder, raise the front
of the ProPass until the front storage stand legs are
off the ground.
11. Remove the two front storage stand legs and store
them.
12. Lower the front of the ProPass onto the frame rails of
the work vehicle.
13. Turn off the engine.
14. Connect the electrical power connection to the work
vehicle (Figure 25 on SH models, Figure 26 on EH
models).
Figure 25: Electrical connection on work vehicle for
SH Model
Figure 26: Electrical connection on work vehicle for
EH Model
Page 21