Possible Cause - Zanussi ZWH6100 P Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Malfunction

Possible cause

Too much detergent or unsuitable
detergent (creates too much foam)
has been used.
Check whether there are any leaks
from one of the inlet hose fittings. It is
not always easy to see this as the
There is water on
water runs down the hose; check to
the floor:
see if it is damp.
The drain hose is damaged.
Too little detergent or unsuitable
detergent has been used.
Stubborn stains have not been
treated prior to washing.
Unsatisfactory
washing results:
The correct temperature was not
selected.
Excessive laundry load.
The program is still running.
The door will not
The door lock has not been released.
open:
There is water in the drum.
The transit bolts and packing have
not been removed.
The support feet have not been
adjusted.
The machine
vibrates or is
The laundry is not evenly distributed
noisy:
in the drum.
Maybe there is very little laundry in the
drum.
Unstable floors eg. wooden floors.
The machine is fitted with a type of
motor which makes an unusual noise
compared with other traditional
The machine
motors. This new motor ensures a
makes an unusual
softer start and more even distribution
noise:
of the laundry in the drum when
spinning, as well as increased stability
of the machine.
22
Solution
Reduce the detergent quantity or
use another one.
Check the water inlet hose
connection.
Change it with a new one.
Increase the detergent quantity or
use another one.
Use commercial products to treat
the stubborn stains.
Check if you have selected the
correct temperature.
Introduce into the drum less
laundry.
Wait the end of washing cycle.
Wait about 3 minutes.
Select drain or spin program to
empty out the water.
Check the correct installation of
the appliance.
Check the correct levelling of the
appliance.
Redistribute the laundry.
Load more laundry.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Zwh6120 p

Tabla de contenido