Setup Instructions - Kathrein UFO DVB-S2-QAM Manual De Instrucciones

Setup instructions

The setting of the 8-way transmodulator DVB-S(2)-QAM (QPSK/8PSK on QAM) is done through the UFG 300 hand controller.
Required controller software version: from version V9.70
For setting up, connect the controller to the module (contains channel units I1 to 8).
The buttons specifi ed below apply to the hand controller (see also the instructions for the UFG 300 hand controller).
The settings and numerical values shown below are intended as an example and do not necessarily match the
Note:
delivery status.
The desired channel unit (1 to 8) is selected using the "<<" or ">>" buttons.
The desired parameter is selected using the "<" and ">" buttons.
The selected parameter fl ashes in the display.
The setting is performed using the "+" and "-" buttons and where necessary using the "Change setting mode" button
The sub-menus are activated and deactivated by pressing the "Sub-menu" button
Finally, press "M" to save the setting in the module.
If the controller is disconnected from the module by pressing the "M" button without saving the settings, after
Note:
around 20 minutes the settings that had last been saved in the module become active again.
The following representation shows the display after plugging in the controller:
O1 1236 MHz
27.500 MS/s
Outp. * S21
6.900 MS/s
Main menu (all symbols shown)
Displays
(*) Left of "TP":
Indicates "desired operating mode not yet reached", displayed continuously in the event of an error.
If the indicator (*) is fl ashing, the channel unit cannot reach its proper operating mode.
The reasons for this include:
• Input frequency or symbol rate set incorrectly
• No input signal
• Front end not clicked into place
Right of "Outp.":
The channel unit output is switched off.
The exclamation mark indicates that the settings of the output symbol rate and QAM stage is not suffi cient for processing
(!)
the input data rate (i.e. the input data rate is greater than the output data rate).
• without the programme fi lter a defective output signal will be output
• with the programme fi lter the data rate can be suffi ciently reduced by fi ltering out individual programmes.
The exclamation mark indicates here that the user should check the correct operation
(P) Left of "TP":
The "P" indicates that the programme fi lter is activated and that some programmes may be removed from the transport
stream.
All manuals and user guides at all-guides.com
* P TP
3/4 QPSK
306.00 MHz
! 256 QAM
.
3 / 11
.