Publicidad
Idiomas disponibles
Idiomas disponibles
8. SUSPENSION LOCATION
8.1 Before determining the suspension location,
thoroughly review the pre-installation checklist
found in Section 5 of this manual. Be sure that the
vehicle is located on a flat and level surface before
measuring for suspension location. When this is
complete, mark the suspension location and
boundaries on the truck frame rails. (See Fig. 1 &
Fig. 2 below for details).
8.2 Prior to suspension installation, any interfer-
ence with existing frame bolts or brackets should
be addressed. If any modification to the auxiliary
suspension is needed, you should consult Link.
NOTE: Truck frame cross-members should be
located at or near the front frame brackets.
PUSHER CONFIGURATION
TAG CONFIGURATION
9. SUSPENSION INSTALLATION
9.1
With suspension location determined, clamp
the front and rear frame brackets to the truck frame
rails.
CAUTION The mounting surfaces of the auxiliary
suspension must be tight against the sides and
bottom of the truck frame rails.
9.2
Double check the suspension location and
check for any interference concerns. Also, check
that drilling will not interfere with any brake or fuel
lines, wiring or other components that might be lo-
cated on the inside of the frame.
9.3 Once the frame brackets are clamped tightly to
the outside and bottom surfaces of the truck frame,
check all clearance issues and then center punch
all mount holes. (See Fig. 3 for recommended
mount hole location.)
9.4 With mount holes marked, drill 21/32'' diameter
holes at hole locations.
FIG. 1
FIG. 2
Publicidad
