Descargar Imprimir esta página

MIRKA AOS-B 130NV Instrucciones De Manejo página 265

Ocultar thumbs Ver también para AOS-B 130NV:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 266
Cleaning
Use a soft brush to remove any accumulated dust. Wear safety glasses to protect your eyes while cleaning.
If the body of the tool needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used.
WARNING: Never use alcohol, petrol or other cleaning agent. Never use caustic agents to clean plastic parts.
Charger cleaning instructions
Dirt and grease may be removed from the exterior of the charger using a cloth or soft non metallic brush. Do not use
water or any cleaning solutions.
Further service
Servicing must always be performed by trained personnel. To keep the tool warranty valid and ensure optimal tool safety
and function, servicing must be carried out by a Mirka authorized service centre. To locate your local Mirka authorized
service centre, contact Mirka Customer Service or your Mirka dealer.
Troubleshooting guide
Symptom
No light from sander right LED when
trigger is pressed.
The sander LED (right) is red and the
sander slows down to 4,000 rpm
when sanding.
The sander LED (right) is red and
rpm is slightly reduced.
The left LED is red and the sander is
not running.
Disposal information
DANGER
Render redundant power tools unusable by removing the power cord.
Observe applicable country-specific regulations regarding disposal and recycling of disused machines,
packaging and accessories.
EU only: Do not dispose electric power tools in house-hold waste. According to European Directives
on waste electrical and electronic equipment and its implementation under national law, electric
tools that have reached the end of their life must be collected separately and taken to an environmen-
tally compatible recycling facility.
For more information regarding REACH, RoHS and our corporate social responsibility visit www.mir-
ka.com
Possible cause
Battery pack not properly attached to
the sander.
Battery totally empty.
Temperature too high in the sander.
Too heavy long term load.
Too heavy short term load.
The battery voltage is too low.
Solution
Insert the battery properly.
Charge the battery.
Reduce the load on the sander for
some time and the sander will speed
up again.
Use lighter load and the LED (right)
will automatically change to green.
Charge the battery.
Mirka® AOS-B 130NV & AROS-B 150NV
en | us-ca
265

Publicidad

loading

Este manual también es adecuado para:

Aros-b 150nv89911503128991230312