Replacing The Backing Pad; Troubleshooting Guide - MIRKA AOS-B 130NV Instrucciones De Manejo

Activate Bluetooth on your Mirka
Connect the battery to the tool.
1.
2. Press and hold the rpm+ button while activating the tool by pressing the switch trigger.
3. Middle LED is flashing green, to indicate that Bluetooth is active and ready for connections.
Middle LED is lit green when the tool is connected to another Bluetooth device.
4.
Bluetooth is deactivated when the tool is deactivated/turned off.
5.
NOTE! If the app is not installed or if it is not available in your country, Bluetooth shall not be activated.
The Bluetooth ® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such
marks by Mirka Ltd is under license. Other trademarks and trade names are those of their respective owners.
Maintenance
Always remove the battery before maintenance!
Only use original Mirka spare parts!

Replacing the backing pad

1. Hold the spindle with fingers.
2. Turn the backing pad counterclockwise to remove it.
Fit and tighten the new backing pad.
3.
Cleaning
Use a soft brush to remove any accumulated dust. Wear safety glasses to protect your eyes while cleaning.
If the body of the tool needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used.
WARNING: Never use alcohol, petrol or other cleaning agent. Never use caustic agents to clean plastic parts.
Charger cleaning instructions
Dirt and grease may be removed from the exterior of the charger using a cloth or soft non metallic brush. Do not use
water or any cleaning solutions.
Further service
Servicing must always be performed by trained personnel. To keep the tool warranty valid and ensure optimal tool safety
and function, servicing must be carried out by a Mirka authorized service centre. To locate your local Mirka authorized
service centre, contact Mirka Customer Service or your Mirka dealer.

Troubleshooting guide

Symptom
No light from sander right LED when
trigger is pressed.
The sander LED (right) is red and the
sander slows down to 4,000 rpm
when sanding.
® AOS-B 130NV & AROS-B 150NV as follows:
Possible cause
Battery pack not properly attached to
the sander.
Battery totally empty.
Temperature too high in the sander.
Too heavy long term load.
Solution
Insert the battery properly.
Charge the battery.
Reduce the load on the sander for
some time and the sander will speed
up again.
Mirka® AOS-B 130NV & AROS-B 150NV
en (original)
65