Functional Description; Adjusting The Nailing Depth; Loading The Nailer - Makita AN911H Manual De Instrucciones

FUNCTIONAL DESCRIPTION

CAUTION:
Always disconnect the air hose before adjusting or
•
checking function on the tool.

Adjusting the nailing depth

CAUTION:
Always disconnect the hose before adjusting the
•
depth of nailing.
009469
1 2
009180
If nails are driven too deep, turn the adjuster clockwise.
If nails are driven too shallow, turn the adjuster
counterclockwise.
The adjustable range is 10 mm (3/8"). (One full turn
allows 0.8 mm (1/32") adjustment.)
Hook
CAUTION:
Always disconnect the hose when hanging the tool
•
using the hook.
Never hang the tool on a waist belt or like.
•
Dangerous accidental firing may result.
1
2
009470
1. Adjuster
1
1. Too deep
3
2. Flush
3. Too shallow
1. Hook
2. Screw
The hook is convenient for hanging the tool temporarily.
This hook can be installed on either side of the tool.
When changing the installation position, remove the
screw with a screwdriver. Install the hook on another
side for installation and then secure it with the screw.
Use the nose adapter
CAUTION:
Always disconnect the hose before installing or
•
removing the nose adapter.
1
009471
If you like to protect the surface of workpiece, attach
the nose adapter of contact element.
When nailing workpieces with easily-marred surfaces,
use the nose adapter. To attach the nose adapter to the
contact element, press it onto the contact element until
the protrusion in three places inside the nose adapter fit
in three holes in the contact element.
ASSEMBLY
CAUTION:
Always disconnect the air hose before loading the
•
nailer.

Loading the nailer

CAUTION:
Make sure that the coil support plate is set to the
•
correct step for used nails.
1
2
009466
Disconnect the air hose from the tool. Select nails
suitable for your work. Depress the latch lever and open
the door and magazine cap.
5
1. Protrusion
2. Hole
3. Nose adapter
2
3
1. Latch lever
2. Door