Duronic AF24 Manual De Instrucciones página 15

Sync Cook mode uses both cooking Zones to either cook both drawers of food on
the same temperature and time, or allows you to use the larger AFD1 drawer to
cook food in.
1. Press the Power Button.
2. Press the Sync Cook button.
3. Press the Zone 1 button.
4.
temperature and time using the Temperature +/- buttons and Time +/- buttons.
5. Press the Start/Pause button.
6. Both cooking zones will begin to heat up and start cooking the food inside.
When the cooking time comes to an end, it will make a beeping noise, both
Zones will stop cooking and the unit will switch itself off.
To check on the progress of your food at any time, press the button for Lamp 1 or
Lamp 2. The light will stay on for a few seconds before switching off again.
The temperature range is 50-200°c. Each time you press the +/- buttons the
temperature will increase or decrease in 10°c increments. If you are on 200°c and
press the + button it will loop back around and adjust to 50°c. Whilst setting the
and then stay on continuously – this means the temperature has been set
successfully.
Sync Cook
14