Installation - Permobil "A" Mounting Block - Permobil BodiLink Head Support Operación Manual

INSTALLATION - PERMOBIL "A" MOUNTING BLOCK

For Permobil Corpus Back Supports (23"-28" height) with UniTrack System using the Permobil "A" Mounting Block.
1
If the head support hardware stem (C) is inserted in the mounting block (B), turn the
knob (A) counterclockwise to release it. Remove the hardware stem; set aside.
2
Using the 5mm hex key, loosen but do not remove the screws (D) to create a gap
between the double nuts (E) and the mounting block (B).
3 Slide the double nuts (E) into the UniTrack System slots and move into position.
4
Tighten the screws (D) with the 5mm hex key to secure.
5
Insert the hardware stem (C) into the mounting block (B) and turn the knob (A)
clockwise to secure.
IMPORTANT! Make sure that at least ½" (1.27cm) of the hardware stem is completely through the bottom of the
mounting block (B) at all times. See the warning in the "Important Safety Information" section in this manual.
Note: See SUPPORT PAD installation, positioning and adjustment instructions in this manual to make final adjustments.
C
B
BodiLink Head Support Operation Manual
E
Track Slots
1
A
10
D
B
E
3
D