Installation - Anterior Mounting Block - Permobil BodiLink Head Support Operación Manual

INSTALLATION - ANTERIOR MOUNTING BLOCK

For back supports where threading from the anterior surface of the shell is necessary or preferred.
1
If the head support hardware stem (C) is inserted into the mounting
block (B), turn the knob (A) counterclockwisze to release it and set it
aside.
2
Loosen the buttonhead screws (D) with the 4mm hex key and remove
along with the washers (E) and the spacer plate (F) from the mounting
block (B).
3
Remove the back support cover (not shown) allowing access from both
sides to the head support holes on the back support shell (G).
4
Align the mounting block (B) and the spacer plate (F) with the available
head support holes on the back support shell (G).
5
Attach (B) and (F) with the screws (D) and the washers (E) from the front
face of the back support shell (G) and tighten.
6
Replace and secure the back support cover.
7
Insert the hardware stem (C) into the mounting block (B) and turn the
knob (A) clockwise to secure.
IMPORTANT! Make sure that at least ½" of the hardware stem (C) is
completely through the bottom of mounting block (B) at all times. See the
warning in the "Important Safety Information" section in this manual.
See SUPPORT PAD installation, positioning and adjustment instructions in this
manual to make final adjustments.
For AGILITY and other compatible back supports that have a 2-hole head support mounting pattern. Instructions
should be used with the images above.
1
Loosen the screws (D) with the 4mm hex key and remove along with the
washers (E) and the spacer plate (F) from the mounting block (B).
2
Use the provided flat head screws* (H) with the countersunk holes in the
spacer plate (F) to attach it to the mounting block (B). Make sure that the screw
heads are flush with the spacer plate (F) when tightened.
*M6 X 1 X 14mm flat head cap screws
3 Align the remaining threaded holes (J) on the spacer plate with the holes on the
back support.
4
Attach, using the provided shorter button head screws (not shown)** and the
existing washers (E).
**M6 X 1 X 8mm button head cap screws
Note: See SUPPORT PAD installation, positioning and adjustment instructions in this
manual to make final adjustments.
BodiLink Head Support Operation Manual
7
D
E
F
D
E
G
B
J
1
C
B
A
F
B
F
H
2