MIRKA ARP-B 300NV Instrucciones De Manejo página 317

NOTE! This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION TO THE USER: Changes or modification not expressly approved by the party responsible for compliance could
void the user s authority to operate the equipment.
Maintenance
Always remove the battery before maintenance!
Only use original Mirka spare parts!
Replacing the backing pad
Hold the spindle with fingers.
1.
2. Turn the backing pad counterclockwise to remove it.
3. Fit and tighten the new backing pad.
Cleaning
Use a soft brush to remove any accumulated dust. Wear safety glasses to protect your eyes while cleaning.
If the body of the tool needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used.
WARNING: Never use alcohol, petrol or other cleaning agent. Never use caustic agents to clean plastic parts.
Charger cleaning instructions
Dirt and grease may be removed from the exterior of the charger using a cloth or soft non metallic brush. Do not use
water or any cleaning solutions.
Further service
Servicing must always be performed by trained personnel. To keep the tool warranty valid and ensure optimal tool safety
and function, servicing must be carried out by a Mirka authorized service centre. To locate your local Mirka authorized
service centre, contact Mirka Customer Service or your Mirka dealer.
Troubleshooting guide
Symptom
No light from the right LED of the
polisher when trigger is pressed.
Possible cause
Battery pack not properly attached to
the polisher.
Battery totally empty.
Solution
Insert the battery properly.
Charge the battery.
Mirka® ARP-B 300NV & Mirka® AROP-B 312NV
en | us-ca
317