MSW Motor Technics MSW-STC-150 Manual De Instrucciones página 36

Then push the profile ends into the openings on the polystyrene cutter and
fasten them. Then tighten the 4 loose screws again.
j) Improper installation will result in the blade not being heated.
k) Optional stops can be installed. These are used to cut the edges of the
Styrofoam. They should be set to the width of the Styrofoam so that the cut will
be centered.
CUTTING INSTRUCTIONS
a) Set the temperature dial to the desired temperature. The higher the number on
the dial, the higher the temperature.
b) Position the blade on the workpiece.