MSW Motor Technics MSW-STC-150 Manual De Instrucciones página 37

c) Turn on the work switch and warm up the tool a few seconds before starting to
cut (making a test cut on waste pieces is recommended).
d) Maintain consistency of temperature and speed. Too much mist/vapor may be
caused by low speed or excessive temperature. This will result in
irregular/uneven cut paths. You can solve this problem by lowering the blade
temperature or loosening the clutch.
e) Let go of the operation switch before the last 3-5 cm of the cut is completed.
f) Proper temperature and cutting speed not only improve productivity, but also
extend tool life.
g) Cutting time should not exceed 60 seconds.