Shutting Down; Directions For Use - hillvert HT-LOGAN-14SA Manual De Instrucciones

Use the adjustment knob (a) to set the preferred nozzle setting (b)
and the amount of chemical used. The knob is marked 1-4, the
consumption values for each setting can be found:
Setting
1
2
3
4
*Note, the above values apply to the device running at maximum parameters.
2. The amount of powdered or granulated agent fed to the outlet tube is
adjusted by moving the lever adjusting the amount of powder/granulate.

3.3.3. Shutting down

1. Move the metering tap to the closed position or the
2. Move the throttle lever to the 0 position.
3. Close the fuel valve.

3.3.4. Directions for use

• The device vibrations may cause the fuel filler cap to loosen or to twist
off when incorrectly locked and lead to leakage. To avoid this
situation, make sure the filler cap is properly tightened before each
use.
• Use the full extension of the blower nozzle so that the air stream is as
close as possible.
• If you notice a decrease in the power of the machine, verify the
condition of the air filter. If necessary, clean or replace it with a new
one
Consumption
(L/min)
1
1.5
2
3
metering lever to the (0) position.