Cleaning And Maintenance - MSW Motor Technics MSW-DA-16 Manual De Instrucciones

• start the welder,
• apply the tool to the concave side of the dent,
• while pressing the trigger of the gun, weld the plate on the end of the gun to the
metal sheet,
• after welding release the trigger,
• pull the indentation out by pulsating while moving the extraction spring
• when finished turn off the welder, disconnect the gun and remove the tool from
the gun holder.

3.4. Cleaning and maintenance

a) Before any cleaning, adjustment or replacement of accessories, and also when
the tool is not in use, make sure that the tool is not connected to the
compressor or welder.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) After each cleaning, all the parts should be dried well before the unit is used
again.
d) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e) Perform regular inspections of the unit checking technical fitness and any
damages.
f) Use a soft, damp cloth for cleaning.
g) Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) for
cleaning, as these may damage the surface of the material from which the unit
is made.
h) Do not clean the unit with acidic substances, medical products, diluent, fuel,
oil or other chemicals as this may cause damage to the unit.