4. Insert the tabletop end piece with the lips into the slots from
left to right. Fasten them using 5/6 M5 x 12 countersunk bolts.
Repeat this operation on the other side, this time from right
to left. Repeat step 3 through 4 for each tabletop assembly.
6. Insert the coupler, with the slots facing upwards, in the middle
of the 2 table legs. Fasten them using 12 M6 x 20 hexagon
socket bolts and 12 lock nuts.
Attention: - use the outer holes if you want a distance of 5 cm
between the tabletops.
- use the inner holes if you want a distance of 0,5 cm
between the tabletops.
5. Put the 2 tabletops nex to each other, with the slots facing
upwards. Now fasten the table leg assembly with the tabletop
connection to the profiles, each time at the intended place,
using 20/24 M6x20 hexagon socket bolts + reinforcement
profiles (also use 10/12 M6x20 hexagon socket bolts). Remove
the spacers.
7. Turn over the table. Level the table by screwing the adjustable
feet in or out and fasten the feet by turning the nu until it sits
against the leg.
english
5