Key Lock - Wilo MAXO Instrucciones De Instalación Y Funcionamiento

Commissioning
The different control modes are:
Selection of characteristic curve (in mode Δp-v, Δp-c, n-const.)
ƒ
ƒ
ƒ
ƒ
Selection of a signal type (during external control) (F02 only)
ƒ
1 = PWM 1
2 = PWM 2
3 =Analogue 0 ... 10 V with cable break function
4 = Analogue 0 ... 10 V without cable break function
ƒ
ƒ
8.3

Key lock

Installation and operating instructions Wilo-Para MAXO/-G/-R/-Z
External control (F02 only)
Variable differential pressure (Δp-v)
Constant differential pressure (Δp-c)
Speed constant
Display of active characteristic curve by 7-segment LED (Fig. I, Item 10):
The number corresponds to the characteristic curve, from 1 (minimum perform-
ance) to 9 (maximum performance).
Press the operating button for a short time to increase the value by 1.
Repeat the process until the desired performance level is reached.
Display of active signal type by 7-segment LED.
Press the operating button for a short time to increase the value by 1.
Repeat the process until the desired performance level is reached.
en
89