Connections - Metra 99-6514B Instrucciones De Instalación

From the 16-pin harness with stripped leads to the aftermarket radio, connect as indicated:
• Red wire to the accessory wire.
Note: If also installing an AXXESS steering wheel control interface (sold separately), there
will be a Red wire on the 6514 harness to connect as well.
• Orange/White wire to the illumination wire. (if applicable)
• Blue/White wire to the amp turn-on wire, if the vehicle is equipped with a factory amplifier.
The following (3) wires are for aftermarket multimedia/navigation radios that require these wires:
• Light Green wire to the parking brake wire.
• Blue/Pink wire to the VSS or speed sense wire.
• Green/Purple wire to the reverse wire.
Tape off and disregard the following (9) wires, they will not be used in this application:
Brown, White, White/Black, Gray, Gray/Black, Purple, Purple/Black, Green, Green/Black
From the 6514 harness to the aftermarket radio, connect as indicated:
• Black wire to the ground wire.
• Yellow wire to the battery wire.
• Gray wire to the right front (+) speaker output.
• Gray/Black wire to the right front (-)speaker output.

CONNECTIONS

• White wire to the left front (+) speaker output.
• White/Black wire to the left front (-) speaker output.
• Green wire to the left rear (+) speaker output.
• Green/Black wire to the left rear (-) speaker output.
• Purple wire to the right rear (+) speaker output.
• Purple/Black wire to the right rear (-)speaker output.
• Yellow RCA jack labeled (Video 2) to either an aftermarket backup camera, or an AUX video input.
• Red & White RCA jacks to the audio AUX-IN jacks.
Note: There is also a set of Green, Green/Black, Violet, Violet/Black wires coming from the
Black 18-pin connector that goes to the interface, tape off and disregard these wires, they will
not be used in this application.
From the 12-pin 6514 harness connector:
• If the vehicle is not equipped with steering wheel controls, disregard this connector entirely.
• If the vehicle has steering wheel controls, the 12-pin 6514 connector is to be used along with
the optional AXXESS steering wheel control interface (sold separately), to retain steering wheel
controls.
• Attach the 12-pin connector from the 6514 harness to the AXXESS steering wheel control
interface and disregard the harness that comes with the interface.
Note: Please verify AXXESS steering wheel control interface connections for your vehicle by
visiting www.axxessinterfaces.com, and using the vehicle fit guide to find a vehicle specific
instruction.
5
REV. 4/19/22 INST99-6514B