Oster 2610 Manual De Instrucciones página 5

LEARNING YOUR HAND/STAND MIXER
You can use the Mixer to mix and knead. The Mixer can be easily removed from the
stand in a moment and used as a standard Hand Mixer.
PREPARING FOR USE
Placing and securing the Mixer to the stand (figure 2).
Before placing and securing the Mixer to the stand, switch unit off "O" and unplug from
the electrical outlet. Place the grooves located in the bottom of the Hand Mixer
(see figure 2) onto the tips of the holding base of the stand. Then push the back of the
Hand Mixer down until it locks into place with a click sound.
To remove it, push the lower end of the Lock & Release Latch and lift the Hand Mixer up
then forward.
INSERTING/ EJECTING BEATERS & DOUGH HOOKS
Before releasing the Beaters or Dough Hooks, switch off the Mixer and remove the plug
from the electrical outlet. Push the Beaters or Dough Hooks into the slots located under
of the mixer, until they click into place. The two Dough Hooks have different plug shapes
and must be pushed into the correct slots. Inserting the wrong way would lead the dough
to "move" upwards. One of the Dough Hooks has an additional small ring near the collar
on the shaft. This Dough Hook will only fit in the slot for which it is intended. To remove
the accessories, hold firmly with one hand, while pressing the Beater Ejector Button
(figure 3).
(figure 2)
(figure 3)
En gl i sh - 4