Connecting Printer, Thermal Printer, Stadiometer, Blood Pressure Monitor, Barcode Reader And Sd400 - inbody 270 Manual De Instrucciones

E. Connecting Printer, Thermal Printer, Stadiometer, Blood Pressure Monitor,
Barcode Reader and SD400
1. Printer
In order to print InBody Results Sheets, an InBody270 compatible printer is required.
* A list of printers compatible with the InBody270 can be found at https://www.inbodyservice.com.
1) First turn off the InBody270 and then the printer.
* You may experience connection issues in connecting the printer to the InBody270 if the InBody is turned on.
2) Plug the USB cable provided with the printer into the USB HOST port on the rear panel of the InBody270
and plug the other end of the USB cable into the printer.
3) Turn on the printer.
4) Turn on the InBody270 and setup your printer under Settings of the Administrator Menu «09. Printer Setup».
5) You can edit your printing settings under Settings of the Administrator Menu from «10. Results Sheet Types»
through «15. Printing Alignment».
2. Thermal Printer
Connect thermal printer to the InBody270 to print Thermal Results Sheet.
* For best result, the InBody270 should be turned off when connecting to thermal printer.
1) Turn off the InBody270.
* For best result, the InBody270 should be turned off when connecting to thermal printer.
2) Connect the serial cable supplied with your thermal printer to the 9-pin serial port on the rear panel of the
InBody270. Then, connect the other end of the serial cable to the serial port on to thermal printer.
3) Turns on the thermal printer.
4) Turn on the InBody270. Go to Setup in Administrator Menu and select 'Thermal Printer' under «26. Serial
Connect».
5) Go to Setup in Administrator Menu and select 'Thermal Results Sheet' under «10. Results Sheet Types» and
configure the items printed to the Thermal Results Sheet under «13. Outputs/Interpretations for Results Sheet».
14
USB HOST port
9-pin serial port