Shop-Vac E4 Serie Manual Del Usuario página 9

FIGURE 26, 27
INSTALLING THE DISPOSABLE FILTER BAG:
(Not standard with all models)
38. Use for dry pick up only. Use in conjunction with
cartridge filter for picking up soot, cement, plaster or
drywall dust.
39. With cord disconnected from receptacle, pull latches
in an outward motion and remove tank cover.
FIGURE 28
INSTRUCTIONS FOR UP AND DOWN
DEFLECTOR:
FIGURE 29
FIGURE 30
37. To clean the cartridge
filter shake or brush off
excess dirt or rinse (from
the inside of the filter)
with water, dry completely
(approximately 24 hours)
and re-install. FIGURE 26,
27. Note: If the filter has
been used for wet pick up,
it must be cleaned and dried
before using for dry pick up.
40. Unscrew hose locking-nut
and remove hose from inlet.
FIGURE 28.
NOTE: Hose must be
removed before inlet deflector
can be taken out.
41. Remove deflector from
retainer guide. FIGURE 29.
42. Make sure curve of the
deflector is in a downward
position, slide collector bag
collar over deflector matching
notches of collar to tabs on
deflector. FIGURE 30.
FIGURE 31
44. When secured in place, expand bag and position
around the inside of tank.
45. Use for dry pickup only.
INSTRUCTIONS FOR SIDE TO SIDE
DEFLECTOR:
1
FIGURE 32
FIGURE 33
FIGURE 34
49. When secured in place, expand bag and position
around the inside of tank.
50. Use for dry pickup only.
43. Slide deflector with
collector bag attached into
retainer guide.
FIGURE 31.
NOTE: Hose must be
removed before inlet deflector
can be taken out.
46. Remove inlet deflector
from deflector guide.
FIGURE 32.
47. With the opening of the
inlet deflector facing the left
or right side of the filter bag,
slide filter bag collar over
deflector matching notches
of bag collar to tabs on inlet
deflector, bag will only fit
properly one way. FIGURE
33.
48. Slide deflector with filter
bag attached into deflector
guide. FIGURE 34.
PAGE 8