Waeco PerfectView CAM16 Instrucciones De Montaje página 24

_RV-16.book Seite 24 Freitag, 13. April 2007 2:33 14
Safety and installation instructions
Observe the following installation instructions:
Secure the parts of the rear view video camera installed in the vehicle in such a way
that they cannot become loose under any circumstances (sudden braking, accidents)
and cause injury to the occupants of the vehicle.
To prevent damage, when drilling ensure that there is sufficient room for the drill head
to come out on the other side (2, page 4).
Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp (see 1 1,
page 3) or a voltmeter (1 2, page 3).
Test lamps (1 3, page 3) with an illuminant take up voltages which are too high and
which can damage the vehicle's electronic system.
When making electrical connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection (3, page 4)
Insulate all connections.
Secure the cables against mechanical wear with cable binders or insulating tape,
for example to existing cables.
The camera is watertight, however, you should observe the following instructions when
handling the camera:
Do not subject the camera to a direct stream from a high-pressure cleaning device.
Do not open the camera, as this impairs the sealing and the function of the camera.
Do not pull at the cables, as this impairs the sealing and the function of the camera.
The camera is not suitable for submerged operation.
24
All manuals and user guides at all-guides.com
PerfectView CAM16