Speed Measurement Of Surface; Rpm Measurement By Reflexion - Minipa MDT-2238A Manual De Instrucciones

Tacómetro foto/contacto digital
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

• Notes:
Depending on the rotating shaft type, you can use the
adapter to measure RPM of the cone or funnel type.
B. Speed Measurements of Surface
1. Select the key functions to the positions "m/min contact".
2. Replace the adapter to measure RPM (cone ou funnel)
for the adapter to measure speed surface.
3. Press the drive button measure and put the adapter
in contact with the surface whose speed is desired to
measure.
C. RPM Measurement by Reflexion
1. Select the key functions to the position "RPM photo"
and remove all adapters to measure by contact.
2. Apply reflective tape to the object being measured.
3. Press the drive button and align the beam to the reflec-
tive tape.
4. Make sure the measurement of the display flashes when
the beam passes through the reflective tape. Release
the drive button when the reading is stabilized (approx.
2 seconds after).
Notes:
• The size of reflective tape used must be approximately
12mm.
• The non-reflective area, where the tape is pasted, must
always be larger than the area of reflective tape.
17

Publicidad

Tabla de contenido
loading

Tabla de contenido