Sleep Timer Operation; Dimmer Control; Resetting The Unit - Tokai TC-155 Manual De Instrucciones

TO SET / RECALL THE RADIO PRESETS
You can preset and store the frequency of 10 radio stations in the memory.
1. Press the POWER ON – OFF / ALARM OFF button once to turn the radio ON.
2. Set radio to desired station.
3. Press and hold the CLK.ADJ./ MEMORY / M+ button and PO1 will flash on
the screen.
4. Press the CLK.ADJ./ MEMORY / M+ button to confirm setting to PO1 or wait
5 seconds for flashing to stop.
5. Repeat the steps above to preset more radio stations.
6. To recall a preset station, press the CLK.ADJ./ MEMORY / M+ button to
toggle through the current preset radio stations.
The sleep timer allows you to play music for a preset amount of time ranging
from 90 minutes to 10 minutes. It is commonly used by people who prefer to go
to sleep to music.
1. In radio mode, Press the SNOOZE/SLEEP/DIMMER button. The display will
show 90 minutes, your clock radio will turn off in 90 minutes.
2. To change the number of minutes for the SLEEP timer, press the SNOOZE/
SLEEP/DIMMER button until you see the desired number of minutes. The
SLEEP timer decreases in increments of 10.
3. To cancel the SLEEP timer, press and the SNOOZE/SLEEP/DIMMER button
then press again until you see OFF in the display or press the POWER ON –
OFF / ALARM OFF button.
In radio off mode, Tap the DIMMER button to set the brightness of the LED
display to high, medium or low according to your ambient light conditions.
Remark:
1. Clock display with dimmer low" is the default setting.
2. It will consume more power if you set the clock display with dimmer high.
If the system does not respond or exhibits erratic or intermittent operation, you
may have experienced an electrostatic discharge (ESD) or a power surge that
triggered the internal microcontroller to shut down automatically. If this occurs,
disconnect the AC POWER CORD from the wall and remove the backup battery
from the compartment. Wait at least 3 minutes, and reinsert the battery for the
back-up, and reattach the AC Cord to the wall. The unit is now reset, so you will
need to setup the unit time and alarms again.
KAI TC-155.indd 19
All manuals and user guides at all-guides.com

SLEEP TIMER OPERATION

DIMMER CONTROL

RESETTING THE UNIT

19
15 12 14 5