Best D49M30SB Manual De Instrucciones página 8

INSTALL FINISH TRIM
WIRE
CONNECTOR
1. Push wires from RIGHT TRIM down through hole at top/right
of chimney. Pull WIRE CONNECTOR all the way to bottom
right side of downdraft housing.
STUD
RUBBER
GROMMET
2. Insert STUD on underside of trim into hole in RUBBER
GROMMET. Make sure trim sits flat on countertop surface
and that wiring is not pinched beneath trim.
GROUND
WIRE
UPPER
RECEPTACLE
LOWER
RECEPTACLE
CABINET BOTTOM
3. Plug wire connector from UP button into UPPER RECEPTACLE
at bottom right side of downdraft housing. Plug ELECTRICAL
PANEL CABLE into LOWER RECEPTACLE and connect
GROUND WIRE to nut as shown.
All manuals and user guides at all-guides.com
Models D49M30SB • D49M36SB • D49M48SB
RIGHT TRIM
(with UP button
and cable)
ELECTRICAL
PANEL CABLE
INSTALL TOP COVER
TOP
COVER
HOLE
1. Slide HOLE in TOP COVER over right trim PIN.
2. Install left trim piece at top/left side of chimney in same manner
as right trim was installed. (Left trim does not have a button
or cable.) Make sure to slide hole in left side of top cover over
left trim pin.
Page 8
PIN