Best D49M30SB Manual De Instrucciones página 9

REMOTE UP/DOWN CONTROL
INSTALLATION
When to use the Remote UP/DOWN Control
The Remote UP/DOWN Control can be used when you cannot
reach the UP/DOWN Button on the downdraft chimney.
The Remote UP/DOWN Control can be used for convenient UP/
DOWN operation of the downdraft chimney.
How to use the Remote UP/DOWN Control
Do not place the remote control where it will interfere with cook-
ing, where hot pans could be set, or where hot liquids could be
spilled on the control.
Remote wiring connects with 6-pin connector on control box.
INSTALL COOKING APPLIANCE
1. Align the cooking appliance with downdraft and fasten appli-
ance in place following appliance instructions.
Note: Accurate alignment of cooking appliance and downdraft is
necessary to ensure that there is no interference when air vent
is raised and lowered. There should be a gap of 1/32" - 1/16" be-
tween the back of the cooktop and the front of the downdraft cover.
MAKE-UP AIR DAMPER
MAKE-UP AIR
DAMPER
CONTACTS
Connects to 2 CONTACTS on ELECTRICAL PANEL.
Compatible with MD6T, MD8T and MD10T damper.
RANGE TRIM KIT
Available for application with free-standing range - where gap is
present between back of range and downdraft.
All manuals and user guides at all-guides.com
(OPTIONAL)
(OPTIONAL)
(OPTIONAL)
Models D49M30SB • D49M36SB • D49M48SB
USE AND CARE
WARNING: Always disconnect electric power
supply before cleaning and/or servicing unit.
Always turn the downdraft blower on before you begin cooking
to establish an air flow in the kitchen. Let the blower run for a few
minutes to clean the air after you turn the cooktop off. This will
keep the whole kitchen cleaner and brighter.
Cleaning
To clean grease filters: Remove front panel and take out the (2)
grease filters. Wash filters in a mild detergent solution or a dish-
washer. Replace filters before using downdraft.
To clean inside chimney: Pull front panel up and out. Remove
filters. Use a mild detergent. DO NOT USE ABRASIVE CLOTH,
STEEL WOOL PADS, OR SCOURING POWDERS. Replace front
panel and filters before using downdraft.
Servicing
It may be necessary to remove the downdraft blower system from
the cabinet in order to service components such as the blower
motor or air vent mechanism.
Disconnect power to the cooktop and remove it first. Reverse the
steps under "INSTALL HOUSING INTO CABINET" to remove the
downdraft from the cabinet.
Page 9