Replacing The Hepa Filter - atmosphere 10-1076 Manual Del Propietário

Fig. 32
Fig. 33a
Fig. 33
Fig. 34
Fig. 35

Replacing the HEPA Filter

1. Turn power off and unplug the Air Purifi er.
2. Remove the front cover from the Air Purifi er using the fi nger tabs located on
each side of the Air Purifi er – near the top (Fig. 32). Steady the Air Purifi er
by fi rst placing your thumbs on the outside edges of the control panel.
Remove the front cover by gently pulling on the tabs with your fi ngers. Then,
pull off the bottom of the cover.
3. The Pre-fi lter attaches to the outside of the HEPA fi lter. Remove the
combined Pre- and HEPA fi lters by squeezing both tabs on either side of
the HEPA frame (near the top) until they unlatch (Fig. 33a).
4. Swing the fi lters out and down away from the housing (Fig. 33).
5. Pull the tab on the center of the pre-fi lter to separate it from the old HEPA
fi lter (Fig.34). Discard the old HEPA fi lter.
NOTE: Vacuum off the Pre-fi lter before attaching it to a new HEPA fi lter even if the Pre-
fi lter monitor light is green.
6. Remove the new HEPA fi lter from the bag (Fig. 35).
16