Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 2
Fig. 3a
Fig. 3
Installation and Set-up
Choosing the Location
Your Air Purifi er can be placed directly against a wall. The housing design
ensures proper clearance between the Air Purifi er and the wall to allow full
circulation of purifi ed air. The Air Purifi er can also be placed in the center of a
room, or in a corner, with no change in effectiveness.
For maximum effectiveness, use the Air Purifi er in a room that's 390 ft
or less. For larger rooms, multiple Air Purifi ers should be used.
Important: Do not locate the Air Purifi er in front of a heating vent. Also, make sure the location
you select will allow the cord to easily reach a wall outlet. The cord is 10 feet (3.05
meters) long.
Preparing the Filters for Operation
The ATMOSPHERE™ Air Purifi er uses three fi lters–pre-fi lter, HEPA fi lter, and
odor fi lter. The HEPA and odor fi lters are shipped in plastic bags to minimize
the spread of carbon dust. Prior to using the Air Purifi er, the plastic bags must be
removed and the fi lters properly re-installed.
Removing the Filters
1. To access the fi lters remove the front cover from the Air Purifi er using the
fi nger tabs located on each side of the Air Purifi er–near the top (Fig. 2).
Steady the Air Purifi er by fi rst placing your thumbs on the outside edges of
the front display label. Remove the front cover by gently pulling on the tabs
with your fi ngers. Then, pull off the bottom of the cover.
2. The Pre-fi lter is attached to the outside of the HEPA Filter. Remove the
combined Pre- and HEPA Filters by squeezing the two tabs located on either
side of the HEPA fi lter frame (near the top) until they unlatch (Fig. 3a).
3. Swing the fi lters out and away from the housing (Fig. 3).
4
2
2
(36 m
)
Publicidad
