Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 41
Fig. 42
Fig. 43
Troubleshooting
Condition
The operation light is on, but air does
not come out of the Air Purifi er.
The volume of air coming out of the Air
Purifi er is high enough, but it doesn't
seem to be removing any dust or odors
from the room.
After the HEPA fi lter was replaced,
the light is still blinking and the Air
Purifi er beeps three times every time I
press a button.
The TURBO button was pressed
mistakenly, or the timer was set for the
wrong length of time.
Replacing the Remote Control Battery
1. Slide tab on the bottom of the remote (Fig. 41).
2. While tab is down, pull battery sleeve out (Fig. 42). Remove old battery.
3. Place a new lithium battery (type CR2032) in the battery holder with the
smaller-diameter section facing down.
4. Snap the battery sleeve back into the remote (Fig. 43).
NOTE: If the sleeve will not go in the battery was installed upside down. Flip the battery
over and snap the battery sleeve closed.
Solution
Check whether the shipping bags have been removed from the fi lters inside the Air Purifi er. (See
INSTALLATION AND SETUP, page 4.) Also, build-up of dirt and/or hair on the pre-fi lter might be
the cause. In this case, clean the pre-fi lter (See CLEANING THE PRE-FILTER, page 12).
Check to be sure both the odor fi lter and HEPA fi lter are installed inside the Air Purifi er. (See
INSTALLING THE FILTERS, page 5).
Reset the HEPA fi lter monitor, using a ball point pen or the end of a paper clip. Press and hold its
RESET button until it beeps.
You can stop Turbo Mode by pressing the TURBO button once. You can disengage the timer by
pressing the TIMER button repeatedly until all the timer lights are off.
Another solution is to turn the Air Purifi er off, then on again. The Air Purifi er restarts in Continuous
operation mode, with the same fan setting from before the unwanted buttons were pushed.
18
Publicidad
