Troubleshooting Guide - Metabo HPT CJ 36DA Manual De Instrucciones

● To avoid injury from an accidental start, turn the switch OFF and remove the plug from the power source
or remove the battery from the main body before making any adjustments.
● All electrical or mechanical repairs should be done only by qualifi ed service technicians. Contact
metabo HPT Authorized Service Center.
1. Power tool
Symptom
Tool doesn't run
Tool suddenly stopped
Blade
- can't be attached
- fall off
Switch can't be pulled
An abnormal high-pitched
noise occurs when the
trigger switch is pulled.
Blade wears out too quickly. Number of strokes is too fast
Unable to properly cut.
Battery cannot be installed

TROUBLESHOOTING GUIDE

WARNING
Possible cause
No remaining battery power
Battery isn't fully installed.
Tool was overburdened
Battery or tool overheated
The shape of the attachment portion
doesn't match
The lever is open.
There is foreign matter inside the blade
holder.
Lock-off button is pushed in.
The trigger switch is being pulled only
slightly.
Proper machine oil not used when
cutting metallic materials
Too much applied pressure during
operation
Blade is inappropriate for the quality and
thickness of the material to be cut
Speed and orbital position are
inappropriate for the quality and
thickness of the material to be cut
Blade is worn, degraded or damaged
Attempting to install a battery other than
that specifi ed for the tool.
Remedy
Charge the battery.
Push the battery in until you hear a click.
Get rid of the problem causing the
overburden.
During operation, lighten the applied
pressure.
Allow the tool and battery to thoroughly
cool.
Use the appropriate blade
(See "Selecting accessories")
Close the lever.
Remove the foreign matter.
Release the Lock-off button.
This is not a malfunction.
It does not occur if the trigger switch is
pulled more fully.
Switch the dial to a lower setting than the
current one.
(Switch to low speed mode when cutting
stainless steel plates)
(See "Adjusting the blade operating speed")
Use machine oil (turbine oil, etc.)
During operation, lighten the applied
pressure.
Use the proper blade
(See "Selecting accessories")
Set the appropriate speed and orbital
position
(See "Adjusting operating speed")
Replace with a new blade.
Please install a multi volt type battery.
English
25