Troubleshooting Guide - Metabo HPT C 3607DRA Manual De Instrucciones

English
● To avoid injury from an accidental start, turn the switch OFF and remove the plug from the power source
or remove the battery or AC/DC adapter from the main body before making any adjustments.
● All electrical or mechanical repairs should be done only by qualifi ed service technicians. Contact
metabo HPT Authorized Service Center.
1. Power tool
Problem
Tool doesn't run
Tool suddenly stopped
Cannot be tilted
Cannot be tilted to the
right
Sawblade is dull
Cannot cut with precision
Switch cannot be pulled
Battery cannot be
installed
42

TROUBLESHOOTING GUIDE

WARNING
Possible Cause
No remaining battery power.
The battery is not fully installed.
Tool was overburdened.
The battery is overheated.
The clamp lever has not been loosened.
Set pin (A) has not been pulled out.
The clamp lever has not been loosened.
The sawblade is worn down or missing
teeth.
Bolt is loose.
The sawblade has been installed in reverse. Install the sawblade in the correct direction.
The operation parts of the tool are not fully
fi xed.
Material cannot be fi xed in the correct
position.
Switch lock is not pressed in enough.
Attempting to install a battery other than
that specifi ed for the tool.
Possible Solution
Charge the battery.
Insert the battery into the tool until you hear
a click.
Get rid of the problem causing the
overburden.
Let the battery cool down.
Loosen the clamp lever and then tilt the
tool.
After adjusting the loosened component,
make sure to tighten it once again.
Tilt to the right after pulling out set pin (A).
Loosen the clamp lever and then tilt.
Exchange with a new product.
Tighten the bolt.
Fully install the clamp lever and side
handle.
Remove any foreign material from the
fence or turntable.
In some cases, proper position cannot be
fi xed due to a curve in the material.
Try to fi x a fl at surface with the fence or
turntable.
Press in the switch lock all the way until it
strikes the back.
Please install a multi volt type battery.