Intended Use - KRESS Mission KR133E Manual De Usuario

Intended Use

The garden product is intended for lawn mowing. It is designed to mow often, maintaining a healthier and
better looking lawn than ever before. Depending on the size of your lawn, Mission
operate at any time or frequency. It is not intended for digging, sweeping or snow cleaning.
Maintenance
Your Mission works hard and needs to be cleaned and checked from time to time. Some parts will require
TM
replacement as they become worn. Never use your Mission
Switch off the machine before carrying out any service or maintenance.
Here's how to take care of your Mission
1
Keep it Sharp
WARNING: Before cleaning, adjusting, or replacing the blades, turn your Mission
put on protective gloves.
WARNING: When fitting new blades, make sure you replace ALL the blades. Always use new
screws when fitting blades. This is important to ensure blade retention and balance the blade
turning disc. Failure to use new screws could cause serious injury.
The Mission does not cut grass like other mowers.
TM
Its cutting blades are razor sharp on 4 edges and
10
rotate in both directions for maximum cutting
EN
capacity. Each blade of your Mission
edges. The blade turning disc will make forward
and reverse rotation at random to use 4 cutting
edges and minimize the frequency of replacing the
blades. And with new material, the service life of
each cutting blade will be 3 times longer than that of
other brands' when it is programmed to mow every
day. Always check to see if the blades are chipped
or damaged and replace them if they are. When the
cutting blades are dull and worn out, they should be
replaced with the spare blades provided with your
Mission . Spare blades are also available at your
TM
nearest Kress retailer .
A. Replace the blades
Usually your Mission
each month and replaced each 2 months. When
replacing the blades, make sure to replace all of them
at the same time. You can replace them with one of the
spare blade kits and extra blade screws supplied with
your Mission .
TM
Before attempting to replace your Mission
blades, turn the power off and put on protective
gloves and follow these steps:
1. Gently flip the Mission
2. Remove the battery cover and remove the
battery.
.
TM
has 4 cutting
TM
's blades need to be reversed
TM
's
TM
over.
TM
TM
with defective on/off switch.
TM
may be programmed to
OFF and
TM
1
2