Mowox RM 750 BTU-SN Manual De Instrucciones página 431

using the cable holders shaped on the station's underside. Connect it to the connector
marked "+", and connect the rear boundary wire to the connector marked S1.
Connect the charging station to the charger
1. Before connecting the charger station to the electric power supply, make sure
that the mains supply voltage is 100 - 240V ~ 50Hz.
2. Plug charger directly into an electrical outlet. Do not abuse the cord. Never carry
anything by or pull on the power cord.
3. Do not operate a damaged charger. Replace damaged cords or charger immedi-
ately at an authorized service centre
4. Do not charge in wet locations. Do not charge at temperatures is above 40° C or
below 5° C.
5. Keep the mower and charger
away from water, heat emitters
or chemicals. Be careful not to
damage the charger cord - by
keeping it away from sharp
edges.
6. Connect the charger to the
charging station. Align the notch
on the power cord connector
with the groove on the adaptor
connector.
Just turn the swivel. Do not attempt to open the factory pre-as-
sembled cable gland into the connector.
LED
off
LED indicator
description
no power
Once these connections are
made, plug in th e power supply.
There is a LED indicator on the
charging station – after proper in-
stallation, it should flash in con-
stant green. If the LED is off,
check the power connections
firstly; I f the LED is on but not
constant green, refer to the trou-
ble shooting guide below.
solution
Check power supply.
21 (EN)