Turn On And Test The Installation - Mowox RM 750 BTU-SN Manual De Instrucciones

LED
constant
green light
on
flashing
green
red
5.5 T
URN ON AND TEST THE INSTALLATION
Once the LED light is constant green, you have a working area for your robot.
Now place your robot into the working area, next to the charging station.
A green flashing LED on the base station indicates wrong in-
Press the main power switch to "ON".
Now press the power soft button
After a short boot of the operating sys-
tem, enter the PIN code "1234" as follows:
Confirm with
again .
Now your mower should follow the wire in an anti-clockwise direction and dock into
t h e charging position. The mower will start to fully charge. If robot misses to
description
ready for mowing (bat-
tery fully charged,
boundary wire OK)
boundary cut off or con-
nected wrongly
battery on charging
stallation of the boundary wire.
OFF (released)
.
, press and then
solution
Correct connection.
Change the two wire ends and check
if the boundary wire has a break
somewhere.
Await full charge or set "Start" – "OK".
ON (pressed)
.
22 (EN)