Starting Operation; Working Advice - Bosch 30-300 Instrucciones De Funcionamiento Y Seguridad

Disconnect battery pack
from tool before making
any assembly, adjustments or changing
accessories. Such preventive safety mea-
sures reduce the risk of starting the tool acci-
dentally.

Starting operation

When starting the power tool, you should first
select the direction of rotation with the rota-
tional direction switch 11 since the power tool
starts only when the rotational direction switch
11 is not in the middle position (switch-on lock)
(Fig. 1).
Reversing the rotational direction
– Right rotation: For driving in screws, push
the rotational direction switch 11 left to the
stop (Fig. 11).
– Left Rotation: For loosening or unscrewing
screws, push the rotational direction switch
11 right to the stop (Fig. 11).
Fig. 11
11
Switching On the Worklight
The work area illumination 13 makes possible
the lighting of the screwing position for unfa-
vorable light conditions. The work area illumi-
nation 13 is switched on by lightly pressing
the on/off switch 10. When the on/off switch
is firmly pressed, the power tool is switched
on and the work area illumination continues
to light.
Do not look directly into
the work area illumina-
tion – your sight can be temporarily de-
graded!
160992A3VR.indb 15
All manuals and user guides at all-guides.com
Operating Instructions
– To start the tool press the on/off switch 10 to
the stop (Fig. 1).
– The tool switches off automatically as soon
as the preset torque is reached.
When the on/off switch 10 is released pre-
maturely, the preset torque is not reached.
To save energy, only switch the power tool on
when using it.
Apply the power tool to the screw/nut only
when it is switched off. Rotating tool in-
serts can slip off.
The tightening torque is dependent on the
spring pretension of the shut-off clutch. The
shut-off clutch responds in right as well as left
rotation when the torque setting is reached.
For setting the individual tightening torques,
use only the adjustment tool 25 provided.
– Push the torques setting cover 6 on the
power tool completely back.
Applies for the following types: ANGLE
EXACT ION 3-500, 8-1100, 15-500, 23-380,
30-290.
Fig. 12
11
– Insert an Allen key 26 into tool bit 1 and turn
it slowly (Fig. 12).
– When a small indentation (adjusting dial 27)
is visible in the clutch, insert the adjustment
15
Switching On and Off
The screwdriver has a shut-off
clutch that can be set for a torque in
a given range. It responds when the
torque that is set is reached.

Working Advice

Setting the Torque
25
1
26
6
27 25
3/7/17 12:22 PM