Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE STARTING
Do not operate this unit until you read this instruction manual for safety,
operation and maintenance instructions.
BEFORE EACH START-UP
1.
Set the On/Off switch (D) to "Off".
2.
Plug the power cord into the correct branch circuit receptacle. (Refer to Voltage and Circuit
Protection paragraph in the Installation section of this manual.)
3.
Turn the regulator knob (G) counterclockwise to set the outlet pressure to zero.
4.
Attach hose and accessories.
Risk of unsafe operation. Firmly grasp air hose in hand when installing or
disconnecting to prevent hose whip.
Risk of unsafe operation. Do not use damaged or worn accessories.
NOTE: The hose or accessory will require a quick connect plug if the air outlet is equipped with a quick
connect body (F).
Risk of Bursting. Too much air pressure causes a hazardous risk of bursting.
Check the manufacturer's maximum pressure rating for air tools and accessories. The regulator
outlet pressure must never exceed the maximum pressure rating.
Risk of property damage. Compressed air from the unit may contain wa ter condensation
and oil mist. Do not spray un fil tered air at an item that could be damaged by moisture. Some air tools and
accessories may require filtered air. Read the in struc tions for the air tools and accessories.
HOW TO START
1.
Set the On/Off switch (D) to "On" and allow tank pressure to build. Motor will stop when tank
pressure reaches "cut-out" pressure.
2.
Turn regulator knob (G) clockwise to increase pressure and stop when desired pressure is reached.
Risk of unsafe operation. If any unusual noise or vibration is noticed, stop the
compressor immediately and have it checked by a trained service technician.
The compressor is ready for use.
CUSTOMER RESPONSIBILITIES
Check Safety Valve
Drain Tank
Remove tank
from service
For more information, call our Customer Care Center at 1-800-262-2161
1-
Risk of unsafe operation. Unit cycles automatically when power is on. When
performing maintenance, you may be exposed to voltage sources, compressed air, or moving
parts. Personal injuries can occur. Before performing any maintenance or repair, disconnect
power source from the compressor and bleed off all air pressure.
NOTE: See Operation section for the location of controls.
TO CHECK SAFETY VALVE (FIG. 2)
Risk of Bursting. If the safety valve does not work properly, over-pressurization
may occur, causing air tank rupture or an explosion.
MAINTENANCE
Before each use
Daily or after
X
10 - ENG
See tank warning label
each use
X
X
1
Publicidad
