Set Open Time / Set Permanent Deadbolt Lock Operation - hafele EFL 30 Manual De Instrucciones

8.3 Set open time / set permanent deadbolt lock operation

Tag-it ™ISO
Prerequisites:
1. Hold the programming key card in front of the
antenna.

Acoustic signal is heard. LED quickly flashes
green for max. 5 seconds.
3. Hold the clearing key card in front of the
antenna again.

The acoustic signal is heard at one second
intervals.

LED flashes green in parallel to the acoustic
signal every second (max. 30 seconds).
The open time can be adjusted at any time, and is also retained after a power supply
interruption or a simple reset.
The open time can be extended to beyond 30 seconds using a macro with the
MDU 110 mobile programming unit with special functions (
41).
After a complete reset or setting the terminal to "permanent deadbolt lock operation",
the set open time is deleted and the factory setting of 3 sec. or the deadbolt lock
operation is active.
If the clearing key card is held out only briefly (< 1 sec.), the terminal switches to
permanent deadbolt lock mode. With the presence of an authorised user key, the
terminal changes its locking status (permanently open or permanently closed).
If permanent deadbolt lock operation is no longer required, an open time must be set.
Programming key card
5 s
2. Hold the clearing key card in front of the
antenna.

1x/s 1x/s
4. Remove clearing key card after the required
time.



Tag-it ™ISO
Clearing key card
x
Acoustic signal is heard. LED continues to
flash green quickly.
LED switches off.
The open time is set for the lock and all
authorised user keys.
 3.2 Technical data, page
55