Working With The Unit - MSW Motor Technics MSW-SPS-18 Manual De Instrucciones

3.2. Working with the unit

CAUTION: Always refer to the vehicle manufacturer's service manual to
determine how to repair vehicle components.
Removing the bearing
a) Prepare the vehicle for removal of the wheel bearing.
b) Install the black shield pair (7) behind the hub flange with the recessed side
facing the hub bracket. Assemble the shield pair (7) with the screws (3).
c) Install the studs (2) in the pressure plate (1). Fit the pressure plate adapter (6)
into the center hole of the pressure plate (1).
d) Slide the main screw (9) into the hole of the pressure plate adapter (6).
e) Lubricate the main screw (1).
f) Slide the other end of the main screw (9) into the bearing hole. Slide the pins
(6) installed in the pressure plate (1) into the holes in the hub flange so that
they fit over the pair of shields (7).
g) Place the black pressure piece (5) on the main screw (9) so that it rests against
the bearing.
h) Thread the nut (10) onto the main screw (9) so that it rests against the pressure
piece (5).
i) Grip the nut (10) and the head of the main screw (9) with suitable wrenches.
Pull the bearing out of the hub holder by turning the head of the main screw.
Mounting the bearing