Self Diagnosis - Valeo Beep&park/keeper Manual De Instrucciones

When reverse gear is selected, the blue digital

indicator indicates 0. m or 0.6m.
1. There are obstacles within 0.6 m.
. Are sensors mounted too low or detecting the ground?
. Check whether the sensor is installed up-side-down.
4. Unplug 1 sensor at a time to check for response.
6
Audible voice or warning sound is too low:
Adjust the volume to a certain level.
If the problem persists, please follow these steps:
1. Contact the dealer where you purchased the product
.
Replace the product ECU and recheck the system.
. Test the sensors with certified ECU using a flat wooden
board.
4. Plug certified sensor into the ECU and recheck.
4 4
All manuals and user guides at all-guides.com

Self diagnosis

When ACC ON, the system will detect the 4 front sensors
E, F, G and H automatically. If they are all functioning,
there is nothing shown on the display and no beeps.
When the reverse gear is selected, the system will
detect the 4 rear sensors A, B, C, D and 2 front sensors
E, H automatically. If all the sensors are functioning, the
system will beep once.
If there is any problem with the sensors, the system will
beep three times to indicate that one or more sensors
are damaged. The locations and the total number of
damaged sensors will be shown on the display. The
others sensors still keep working as normal.
The 2 front sensors will work for 30 seconds after exit
from reversing gear and then stop automatically.
Total number of
damaged sensors
The locations of
damaged sensors