Rear Panel - FONESTAR DMX-83 Manual De Instrucciones

5.-
a.- BANK UP, BANK DOWN: allow you to select from the 30 available
banks for scene selection and programming.
b.- PROGRAM: allows the scene programming mode to be activated.
The PROGRAM indicator will flash on the display.
c.- ADD: Allows you to add the functions selected during the
programming mode.
d.- AUTO/DEL: allows you to activate automatic mode. The AUTO
TRIGGER indicator will light on the display.
e.- MUSIC/BANK COPY: allows you to activate sound activation
mode.
The MUSIC TRIGGER indicator will light on the display.
f.- DISPLAY/TAPSYNC: allows you to switch between different
displays on the screen.
In automatic mode, you can manually set the speed by clicking on it two times (start and stop.
g.- CHASE 1-6: allows to select each of the programmable chase memories.
h.- BLACKOUT: causes a blackout effect at all output channels. All channels will be reset to 0 when
this control is activated. The BLACKOUT indicator will flash on the display when this mode is active.
6.- Scrolling controls that allow you to adjust the output value of each of the channels between 0 and 255.
Depending on the PAGE A/B control, you can control either channels 1 to 8, or 9 to 16.
7.- PAGE A/B: allows you to select between channels 1 to 8 (PAGE A) or 9 to 16 (PAGE B). The LED indicator
for each group will appear green when it is active.
8.- SPEED: scrolling control that allows you to adjust the duration of each scene within a chase in automatic
mode. The minimum value is 0.1 second, and the maximum is 9 min 59 seconds.
9.- FADE TIME: scrolling control that allows you to set the transition time between scenes within a chase
in automatic mode. If the FADE TIME control is set to position 0, switching between scenes will be
instantaneous. The minimum value is 0 seconds and the maximum is 30 seconds.

REAR PANEL

1.- POWER: On/off switch for the device.
2.- DMX POLARITY: polarity selector on pins 2 and 3 of the XLR connector.
3.- DMX OUTPUT: control signal output. 3 pin XLR connector.
4.- DC INPUT: power input by means of a power adapter.
- 3 -
EN