Descargar Imprimir esta página

Legrests; Fitting/Removing Legrests; Height Adjustment Of The Calf; Angle Adjustment Of The Leg - B+B S-VR Manual De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

S-VR
| Multifunctional wheelchair

6.2. Legrests

6.2.1. Fitting/removing legrests

You can flip the footplates up separately to the side and adjust to the
lower leg length of the user (see Chapter 6.3). You can remove the
legrests, swing them away and refit them without needing to use tools.
Attach legrests
The legrests are inserted into the receivers on the frame (Fig. 9).
Then swivelled inwards with a gentle push. Done.
To disassemble the legrest, pull the lever (Fig. 10) on the inner side,
10
swivel the legrest back out and pull it out of the receiver.
Legrest with footplate
Both legrests are delivered with footplates fitted.
When seated, the footplates on both legrests can be flipped up
(Fig. 8).
Before setting off, fit the legrests as described above.
9
50
When folding and unfolding, watch your fingers
as there is a risk of pinching
Never stand on the footplate and when swinging
it away, watch your fingers as there is a risk of
pinching
Multifunctional wheelchair |

6.2.2. Height adjustment of the calf

pad
Flip the calf pad forwards (Fig. 11).
Move it to the height required. 3 heights are possible
The calf pad is then swivelled back.

6.2.3. Angle adjustment of the leg-

rest
The legrests can be adjusted separately up to 90°. Push the locking
lever down (Fig. 12).
swivel the legrest by simply pulling it upwards to the required
position and then let go of the lever
the legrest will lock into place automatically
To move the legrest into a lower position or the initial position, pull
the locking lever and push the legrest back to the required position.
To change seat, the legrest must be swung away
or removed. Never sit on the legrest. Risk of tipping
over!

6.3. Adjusting the legrest

length
The length of the legrest can be infinitely adjusted using the telescopic
tube.
Undo the hexagon head screw (SW13) by turning it to the left (Fig.
13).
Adjust the legrest as required
Re-tighten the screw by turning it to the right.
To change seat, the legrest must be
swung away or removed. Never sit on
the legrest. Risk of tipping over!
Bischoff & Bischoff GmbH |2022-06-30 - Revision: 1
S-VR
11
12
13
51

Publicidad

loading